Rlide R2 Series - Offset Functions; Distance Offsets

56
b.
Enter the first point (P1) of the line. ※1)
Enter the 1st
point of the line.
[ENT]
Input P1
P1:
1
P2:
Meas
List
Stac
c.
Enter the second point (P2) of the line.
Enter the
second point of
the line.
[ENT]
Input P2
P1:
1
1
P2:
Meas
List
Stac
d.
Enter offsets to the line. Press [ENT] in a
blank field to enter the value 0.0000.
Sta：Distance from P1 along the line.
O/S：Offset to beeline
(+): Right side of the P1-P2 line
(-): Left side of the P1-P2 line
Dz: dVD to line
Enter offsets
Input OS
STA:
1
O/S:
dZ:
* Dist to P1
e.
Start stakeout. Rotate the instrument
until the dAZ is close to 0°00'00" Sight
the target and press [MSR1]/ [MSR2]
dAZ: Azimuth error to target point
HD: Distance to target point
[MSR 1]/
[MSR 2]
Ref.Line
<1/8>
dAZ
23°41’23”
HD#
17.071m
* Sight Press [MSR]
OK
f.
After measuring, the deviation value
between measure point and stakeout
point is shown. ※1)
dHA: Difference in horizontal angle to
the target point
R/L Right/Left (Lateral error)
IN/OUT In/Out (Longitudinal error)
CUT/FIL Cut/Fill
PT
1/8
dHA
0°00’00”
STP
0.000m
IN
3.971m
FIL
0.743m
* Press [ENT] Rec
g.
Ask the rodman to adjust the target
position. When the target is on the
intended position, the displayed errors
become 0 m.
：moving towards to station
：moving away from station
SO
1/8
dHA
0°00’00”
STP
0.000m
STP
0.000m
FIL
0.201m
* Press [ENT] Rec