Rlide R2 Series - View Records

116
Dist.
SeaLevel: ON/OFF
C&R crn: OFF/0.14/0.200
Max Dist: 2000m/5000m (Select max range of laser distance measurement, only for
reflectorless total station.)
XYZ
Order: NEZ/ENZ
Marker: NEZ/XYZ/YXZ
AZ 0: North/South
Power
Power off: 5 min/10 min/30 min/ OFF
EDM off: Now/0.1 min/0.5 min /3 min /10 min/ OFF
Sleep: 1 min/3 min/5 min/OFF
Comm
Mode: Ruide/Setting
Baud: 1200/2400/4800/9600 /19200/38400/57600/115200
Data.L: 8/7
Parity: None/Even/Odd
Stop: 1/2
SO
Add PT: This field sets the default point number to record observed data in stakeout.
Unit
Angle: DEG/GON/MIL
Dist: Meter/USA Feet/USA Inch/IntlFeet/IntlInch
Temp: °C/°F
Press: hPa/mmHg/inHg
Record
Store DB: RAW+XYZ/RAW/XYZ
This setting determines whether raw and/or coordinate data is stored when you record
SS, CP, or SO records in the Basic Measurement Screen (BMS) or Stakeout screen.
REC Data: MEM./COMM
Set this item to COM to output data on the COM port. The data is not stored to the job
file.
Other
XYZ Dsp: Quick/Normal/Slow/Enter
Defines speed to move to the next screen after showing XYZ of the input PT.
2nd Unit: Meter/USA Feet/USA Inch/IntlFeet/IntlInch/None
Beep: ON/OFF
Split ST: ON/OFF
You can separate the point numbers of station points from other record type point
numbers. If you set the Split ST ON, you can enter single ST number in an additional
setting screen. Or you can press [ENT] to use default point name.
InputCod: ALPH/NUM
User Information: Enter your information up to 20 characters.
11.4 VIEW RECORDS
You can view data at any time, even in an observation screen or while entering points.