Rlide R2 Series - Coordinates Stakeout

51
5.2 COORDINATES STAKEOUT
Input the XYZ of stakeout point, and carry on stake-out.
STEP
OPERATION
DISPLAY
c.
In SO menu, press [2] to enter to
coordinate stakeout function.
[2]
SO
1. HA-HD
2. XYZ
3. PartLine
4. Ref.Line
d.
A
Enter the point name that you want to
stake and press [ENT]. After finding the
input point name, program proceeds to
Step d. To display the coordinates, press
[ENT] to confirm.
A
Input PT
PT:
2
1
Rad:
12.000m
CD:
Fr/To
List
Stac
B
Specify the point by code or radius from
the instrument. (As shown in graph B).
C
Specify a stakeout list by range input. To
input points by range, press the Fr/To
softkey in the PT field., as shown in right
graph C. Enter the start point (Fr) and the
end point (To). The last digit of point
name must be a number. If existing
points are found between Fr and To, a
point list is displayed, see Step c.
B
Input PT
PT:
1
Rad:
12.000m
CD:
Fr/To
List
Stac
C
Input PT range
Fr:
1
To:
List
Stac
e.
If several points are found, they are
displayed in a list. Then use [ ]/[ ] and
[▲]/[▼] to select needed point, and
press[ENT]. ※2)
MP,1,
MP,4,
MP,6,
MP,8,
Ctrl