Rlide R2 Series - Page 54

52
f.
Screen displays coordinates of the
selected point name, press [ENT] to
confirm.
[ENT]
N:
10.000m
E:
10.000m
Z:
6.180m
PT:
4
CD:
List
Stac
g.
The delta angle and the distance to the
target (HD) are shown. Rotate the
instrument until the dAZ is close to
0° 00'00", press [MSR1]/ [MSR2].
dHA: Difference in horizontal angle to
the target point
HD: Distance to the target point
[MSR 1]/
[MSR 2]
PT:4
dAZ
123°41’23”
HD#
7.071m
* Sight Press [MSR]
OK
h.
After measuring, the deviation value
between measure point and stakeout
point is shown. ※1)
dHA: Difference in horizontal angle to
the target point
R/L Right/Left (Lateral error)
IN/OUT In/Out (Longitudinal error)
CUT/FIL Cut/Fill
PT
1/8
dHA
0°00’00”
STP
0.000m
IN
3.971m
FIL
0.743m
* Press [ENT] Rec
i.
Ask the rodman to adjust the target
position. When the target is on the
intended position, the displayed errors
become 0m.
：moving towards to station
：moving away from station
SO
1/8
dHA
0°00’00”
L
0.000m
IN
0.000m
FIL
0.201m
* Press [ENT] Rec
j.
When both R/L and IN/OUT display 0m,
it indicates the prism is on the stakeout
point.
The fifth line shows the data of fill or dig.
SO
1/8
dHA
0°00’00”
L
0.000m
IN
0.000m
FIL
0.201m
* Press [ENT] Rec
k.
After staking out, your can press [ENT] to
record the stakeout point. PT defaults to
the last recorded PT+1, you can input
code if necessary. Press [ENT] to record
the point.
[ENT]
N:
10.000m
E:
10.000m
Z:
6.180m
PT:
4
CD:
List
Stac