Rlide R2 Series - Angle Offsets

57
h.
When both R/L and IN/OUT display 0m,
it indicates the prism is on the stakeout
point.
The fifth line shows the data of fill or dig.
SO
1/8
dHA
0°00’00”
STP
0.000m
STP
0.000m
FIL
0.201m
* Press [ENT] Rec
i.
After staking out, you can press [ENT] to
record the stakeout point. PT defaults to
the last recorded PT+1, you can input
code if necessary. Press [ENT] to record
the point.
[ENT]
N:
10.000m
E:
10.000m
Z:
6.180m
PT:
221
CD:
List
Stac
j.
After recording the point, the display
returns to the SO screen. Press [ESC]
to reinput the offsets. Repeat Step d – I
to do Ref.Line stakeout.
Input OS
STA:
1
O/S:
dZ:
* Dist to P1
※1) About method to input PtID, please refer to “2.8 METHOD TO INPUT PTID”.
All observation results display in 8 pages: press [▼] or [DSP] to switch between display screens. Detailed
introduction please refer to “HA-HD SO”.
5.5 GUIDE LIGHT
※ Only Available on R2 Pro.
By emitting two visible beams of coherent light, one red and one yellow, enabling the rodman to locate the
correct line quickly and easily by finding the position where both light blink alternately.
STEP
OPERATION
DISPLAY
Press numeric key [8] to enter to stake-
out function. The screen will show “Open
the guiding light?”. Press [MSR1] to
cancel or press [ANG] to activate the
guide light function.
[8]
<Set>
Open the guiding light?
CE
OK
 When only seeing the yellow light, move the prism to the right
 When only seeing the red light, move the prism to the left.
 When seeing both lights blinking alternately, it means the prism is in the correct line.