“All” is a quick shooting and recording mode. The instrument automatically records the point using the default
PtID, and then returns to the basic measurement screen.
“Meas” is the default measuring mode. After a measurement, the instrument stops in the BMS and waits for you
to press [REC/ENT] before recording the point.
※2) The measurement mode setting of [MSR2] is the same as it. When pressing [MSR1] or [MSR2], the system
activates the corresponding measurement mode to measure.
3.3 HOT KEY
[HOT] Key includes the inputting function of target height, temperature & pressure, target selection and note.
It is available on any observation screen.
3.3.1 Set the Height of the Target
To change the height of the target (HT) or temperature, pressure, press [HOT].
a.
Press [HOT] to display the [HOT] key
menu.
b.
Press [1] to enter into HT setting
function.
c.
Enter the height of the target manually
or press the [Stac] softkey to display the
HT stack. The HT Stack stores the last
20 HT values entered. As shown in the
right.
Input target
height
or
[Stac]
To Next Page
Loading...