l.
A: After recording the point, the display
returns to the observation screen. You’re
your press [ESC], the display returns to
the PT/CD/R input screen. If you
entered the stakeout point using a single
point name, PT defaults to the last
PT+1.
B: If you selected a point from the list,
the display returns to the list, unless all
points have been selected. Press ESC]
to return to the point input screen.
※1) Once a measurement is taken, the Cut/Fill value and Z coordinate are updated as the VA is changed.
※2) If you have assigned a control job, and additional points are found in the control job, the Ctrl softkey is
displayed under the list.
※3)Use the Add Constant field in [MENU]→[3.Set]→[6.SO] to specify an integer that is added to the point
number being staked to generate a new number for recording the staked point.
For example, when you stake out PT3 with an Add Constant of 1000, the default number for SO record is
1003.When there are letters in the point name, put the Add Constant after the letter.
For example: When you stake out AD12 with an Add Constant of 1000，the default number for SO record is
AD1012.
All observation results display in 8 pages: press [▼] or [DSP] to switch between display screens. Detailed
introduction please refer to “HA-HD SO”.
5.3 PARTLINE SO
This function divides the line between the instrument and the target by an input span number. It then
guides you to stake out the points, one by one.
For example, if you measure to the end point at 100 m from the instrument and set the span total to 2, the
following four points are calculated and can be staked.
<1/2> <2/2> <3/2> <4/2>
HD=
50m 100m 150m 200m
To Next Page
Loading...