Rlide R2 Series - Quick Codes

30
b.
Rotate the horizontal circle to needed
horizontal angle, or input the needed
angle value manually.
Angle
HA: 60°00’00”
1.0SET
4.F1/F2
2.Input
5.Hold
3.Rept.
c.
Press [5] to enter into angle hold function.
Use the horizontal clamp screw or
horizontal tangent to sight the target.
[5]
HA Hold
HA: 60°00’00”
* HA is hold
Press [ENT]
d.
Press [ENT] to set the horizontal angle of
the target.
[ENT]
Display
1/4
HA#
20°00’00”
VA#
273°13’45”
SD#
PT:1
HT:
1.000m
3.6 QUICK CODES
Quick codes (Qcodes) let you shoot and record many points with feature codes in the field.
Using the quick code function, a predefined code can be called up directly via numeric keypad on the
instrument. The code is selected by entering a two-digit number, by pressing [MSR1] the measurement is
triggered and the measured data and code saved.
A total of 256 quick codes can be assigned. Each code can be assigned a unique one/ two/three digit
numbers. If no numbers are allocated to the codes, the code is selected in accordance with the order in
which the codes were entered in the code list (e.g.: 01->: first code in the code list. 10-> tenth code in the
code list).About editing Quick Code, please refer to “11.4.14.4 Add a code”; users can also use the data
transferring software provided by RUIDE to create and upload codes, please refer to “Appendix A 3: Code
List”．
STEP
OPERATION
DISPLAY
a.
In basic measurement screen, press
[Mode] to enter into Quick Code function.
Display
1/4
HA#
20°00’00”
VA#
273°13’45”
SD#
PT:1
HT:
1.000m