To change the height of the target (HT), temperature, or pressure, press [HOT].
Settings that relate to corrections (T-P, Sea level, C&R) are included in the job settings. These settings
are job-specific. Changing of any item will create a new job or shut off all jobs.
The maximum capacity of R2 Serial is defined by the data type. Up to 10000 points can be collected at
most.
3.5 ANGLE MEASUREMENT
To open the Angle menu, press [ANG] in the basic measurement screen.
b.
To select a command from this menu,
press the corresponding number key
and [ENT].
To Next Page
Loading...