Rlide R2 Series - Page 119

117
11.4.1 View Raw Data
STEP
OPERATION
DISPLAY
a.
In [Menu] press numeric key [4] (or use
[▼] + [ENT]) to enter into data function.
[Menu]
Menu
1.Job
6.1 Sec.
2.Cogo
7.Adjust
3.Set
8.Time
4.Data
9.Format
5.Comm
10.Info
b.
The data menu displays. Press numeric
key [1] choosing the raw data function.
[1]
View/Edit
1. Raw
Data
2. XYZ
Data
3. ST→SS/SO/CP
4. PT List
5. Cod
List
c.
The raw data records show in a list. The
cursor stays on the last raw data record
of current job. Use [▲]/[▼] to choose
the records. ※1)
[▲]/[▼]
RAW Data
F1,10,
F2,10,
CP,9,V
SS,5
Del
Edit
Srch
d.
To see detailed information for the
selected records, press [ENT]. Press
[ESC] to return to the record list. ※2),※
3)
[ENT]
HA#
47°25’14”
VA#
94°56’15”
SD#
3.345m
PT:
5
HT:
1.000m
Del
Edit
Dsp
[Dsp]
N:
10.000m
E:
10.000m
Z:
10.000m
PT:
10
CD:
RUIDE
Del
Edit
Dsp
※1)SS：Sideshots (topo shots). All shots from the basic measurement screen are stored as SS records.
CP：Shots taken in the Angle or Repeat menus, or in the basic measurement screen.
F1/F2：Face-1 /Face-2 measurements.
※2) Raw records contain “PT”, “HT”, “CD” and “HA/VA/SD”.
※3) When the Store DB setting is set to RAW+XYZ, press [DSP] to switch between the screens.
When you take more than one measurement to the same point and choose to overwrite the XYZ data,