Rlide R2 Series - Page 40

38
e.
Enter the target height and press [ENT].
Enter the target
height
+
[ENT]
Input PT01
PT:
1
1
HI:
1.800m
CD:
List
Stac
f.
Sight the center of first target prism on
F1and press [MSR1] or [MSR2] to start
survey. If only need to measure angle,
press [ENT].
If the horizontal circle is on Face-2,
screen would display “Turn to F1”. As
show in the right graph. Rotate the
telescope and alidade, and sight the BS
point in Face-1.
Sight
+
[MSR1]/
[MSR2]
RESE <Sight 01>
HA#
30°21’50”
HD#
SD#
* Press [MSR]/[ENT]
F2
1
* Turn to F1
g.
The measuring result is displayed, press
[ENT].
To measure the backsight point on
F2，press [F2] softkey. Rotate the
telescope and alidade, and sight the
center of target prism, and press
[MSR1] or [MSR2]. Press [ENT] after
measuring.
[ENT]
RESE <Sight 01>
HA#
30°21’50”
HD#
2.032m
SD#
2.040m
* Press [ENT] Next
F2
F2
Stn Setup
1/2
HA:
30°21’50”
* Turn to F2
* Press [ENT] Next
h.
If measured on F1 and F2, a QA screen
appears, press [OK] or
[ENT] to record the result.
[OK]
or
[ENT]
Stn Setup
1/2
dHA:
0°00’05”
dVA:
-0°00’01”
dSD:
0.001m
* Press [ENT] Rec
Abrt
CP
OK