FIGURE 9-1 GROUND HANDLING WHEELS
1. Insert spindle into skid-mounted support.
4. Handle is in locked position when parallel with the skid.
2. Verify flange is outboard of cradle.
3. Pull handle in rearward arc to raise helicopter.
NOTE
R66 ground handling wheels are installed inboard of landing
gear skid tubes. C063-5 (LH) and C063-6 (RH) ground handling
wheel assemblies are not interchangeable. When wheels are
installed and in locked position, both handles point aft.
Page 9.2 Chapter 9 Ground Handling R66 Maintenance Manual 25 OCT 2010
To Next Page
Loading...