97-30 Garmin GTX 33 Transponder Installation (continued)
G. Special Maintenance and Inspections
1. Turn battery & avionics switches off. Open circuit breaker panel.
2. Remove GTX 33 transponder per Part C. Inspect condition of and verify no obvious
damage to transponder, radio tray, copper bus bars, circuit breaker, and wiring. Verify
no loose, chafed, or broken wires or terminals. Verify no evidence of arcing.
3. Secure circuit breaker panel. Install transponder per Part D.
Page 97.14 Chapter 97 Avionics MAY 2015
To Next Page