Robotiq Screwdriving Solution - Instruction Manual
3.2.2.Robotiq Screw Feeder
l
4 screws to mount the Screw Feeder brackets on the work surface (not included).
l
Metric or imperial key corresponding to the fasteners used to mount the Screw Feeder on your work surface (not included).
l
2.5 mm slotted screwdriver to attach the wires of the I/O signal and ground cable to the robot controller (not included).
l
10 mm wrench to fasten the earthing nut on the robot cabinet (not included).
19
To Next Page
Loading...
