2.Safety
Info
The term “ operator” refers to anyone responsible for any of the following operationson the Robotiq Screwdriving
Solution:
l
Installation
l
Control
l
Maintenance
l
Inspection
l
Calibration
l
Programming
l
Decommissioning
Warning
The operator must have read and understood all of the instructions in the following manual before handling the Robotiq
Screwdriver and Screw Feeder.
2.1.Disclaimer
The intent of thissection isto provide general guidelines for the safe use and operation of the Robotiq Screwdriving Solution.
Alwaysfollow local regulations.
This documentation explainsthe variouscomponents of the Robotiq Screwdriving Solution and general operationsregarding the
whole lifecycle of the product from installation to operation and decommissioning.
Robotiq accepts no liability for damage, injury or any legal responsibility incurred directly or indirectly from the use of this product.
The operator shall observe safe and lawful practicesincluding but not limited to those set forth in this document.
The drawings and photos in thisdocumentation are representative examples; nonetheless, discrepancies may be observed
between those and the delivered product.
2.2.Warnings, Risk Assessment and Final Application
Caution
Any use of the Screwdriving Solution in non-compliance of these warningsisinappropriate and may cause injury or
damage.
Caution
It is the robot integrator's duty to ensure that all local safety measuresand regulationsare met.
Robotiq Screwdriving Solution - Instruction Manual
12
To Next Page
Loading...
