Robustel R1520 User Guide
RT056_UG_R1520_v.1.0.3 Dec. 25, 2021 138/159
When finished, click Submit > Save & Apply for the configuration to take effect.
5.1.2 SMS Remote Control
The router supports remote control via SMS. You can use following commands to get the status of the router, and set
all the parameters.
There are three authentication types for SMS control. You can select from “Password”, “Phonenum” or “Both”.
An SMS command has the following structure:
1. Password mode—Username:Password;cmd1;cmd2;cmd3;…cmdn (available for every phone number).
2. Phonenum mode-- Password;cmd1;cmd2;cmd3;… cmdn (available when the SMS was sent from the phone
number which had been added in R1520’s phone group).
3. Both mode-- Username:Password;cmd1;cmd2;cmd3;…cmdn (available when the SMS was sent from the phone
number).
Note: All command symbols must be entered in the English input half angle mode.
SMS command Explanation:
1. Password: The SMS control password defaults to the login password of the super user or the login password of
the ordinary user who has read and write permissions.
2. cmd1,cmd2,cmd3 to cmdn, the command format is the same as the CLI command, more details about CLI cmd
please refer to Chapter 6 Introductions for CLI.
Note: Download the configure XML file from the configured web browser. The format of SMS control command
can refer to the data of the XML file.
Go to System > Profile > Export Configuration File, Select export type as "complete", click
to
generate the XML file and click to export the XML file.
To Next Page
Loading...
Need help?
General