Rockwell Automation Allen-Bradley PowerFlex 520 Series - AppView and CustomView Parameter Groups

150 Rockwell Automation Publication 520-UM001K-EN-E - August 2021
Chapter 3 Programming and Parameters
AppView Parameter Groups AppView parameter groups provide a simple starting point for using the
PowerFlex 520-series drives by grouping certain commonly used parameters
based on different types of applications. Use these parameter groups to quickly
and easily setup the PowerFlex 520-series drive for your application.
AppView parameter groups are available for the following applications:
•Conveyor
•Mixer
• Compressor
•Centrifugal Pump
•Blower/Fan
•Extruder
• Positioning (PowerFlex 525 only)
• Textile/Fiber
You cannot add or remove parameters to or from the AppView parameter
groups. If you require quick access to additional parameters to what is already
included in the different AppView parameter groups, use the CustomView
parameter group instead.
The parameters in the AppView parameter groups can be quickly added to the
CustomView parameter group by doing the following:
Step Key(s) Example Displays
1.
Press the Up Arrow or Down Arrow to scroll to
an AppView group (G1...G8).
2.
Press Enter or Sel to enter a group. The right
most digit of the last viewed parameter in
that group will flash.
3.
Press the Up Arrow or Down Arrow to scroll to
the command G1->GC.
4.
Press Enter or Sel to add all the parameters
in this AppView group to the CustomView
group. The LCD display will show a
confirmation.
or
F W D
Sel
or
F W D
or
F W D
Sel
or