60 Rockwell Automation Publication 520-UM001K-EN-E - August 2021
Chapter 2 Start Up
Control and Navigation Keys
Display Display State Description
ENET (PowerFlex 525 only)
Off Adapter is not connected to the network.
Steady
Adapter is connected to the network and drive is controlled
through Ethernet.
Flashing
Adapter is connected to the network but drive is not controlled
through Ethernet.
LINK (PowerFlex 525 only)
Off Adapter is not connected to the network.
Steady Adapter is connected to the network but not transmitting data.
Flashing Adapter is connected to the network and transmitting data.
LED LED State Description
FAULT Flashing Red Indicates drive is faulted.
Key Name Description
Up Arrow
Down Arrow
Scroll through user-selectable display parameters or groups.
Increment values.
Escape
Back one step in programming menu.
Cancel a change to a parameter value and exit Program Mode.
Select
Advance one step in programming menu.
Select a digit when viewing parameter value.
Enter
Advance one step in programming menu.
Save a change to a parameter value.
Reverse
Used to reverse direction of the drive. Default is active.
Controlled by parameters P046, P048, and P050 [Start Source x]
and A544 [Reverse Disable].
Start
Used to start the drive. Default is active.
Controlled by parameters P046, P048, and P050 [Start Source x].
Stop
Used to stop the drive or clear a fault.
This key is always active.
Controlled by parameter P045 [Stop Mode].
Potentiometer
Used to control speed of drive. Default is active.
Controlled by parameters P047, P049, and P051
[Speed Referencex].
To Next Page
Loading...
Need help?
General
