82 Rockwell Automation Publication 520-UM001K-EN-E - August 2021
Chapter 3 Programming and Parameters
Basic Program Group
P030 [Language] Language Support
Selects the language displayed. A reset or power cycle is required after selection is made.
Keypad/
LCD Display
RSLogix 5000/Logix
Designer application
Connected
Components
Workbench software
Options
1English (Default) Y Y Y
2Français Y Y Y
3Español Y Y Y
4Italiano Y Y Y
5 Deutsch Y Y Y
6 Japanese – Y –
7Português Y Y –
8 Chinese Chinese Simplified – Y Y
9 Reserved
10 Reserved
11 Korean – Y –
12 Polish
(1)
Y– –
13 Reserved
14 Turkish
(1)
Y– –
15 Czech
(1)
Y– –
(1) Due to a limitation of the LCD Display, some of the characters for Polish, Turkish, and Czech will be modified.
P031 [Motor NP Volts] Related Parameter(s): b004, A530, A531, A532, A533
Stop drive before changing this parameter.
Sets the motor nameplate rated volts.
Values
Default: Drive Rated Volts
Min/Max: 10V (for 230V Drives), 20V (for 460V Drives), 25V (for 600V Drives)/Drive Rated Volts
Display: 1V
P032 [Motor NP Hertz] Related Parameter(s): A493, A530, A531, A532, A533
Stop drive before changing this parameter.
Sets the motor nameplate rated frequency.
Values
Default: 60 Hz
Min/Max: 15/500 Hz
Display: 1 Hz
P033 [Motor OL Current] Related Parameter(s): t069, t072, t076, t081, A484, A485, A493
Sets the motor nameplate overload current. Used to determine motor overload conditions and can be set from 0.1 A to 200% of drive rated current.
Values
Default: Drive Rated Amps
Min/Max: 0.0/(Drive Rated Amps x 2)
Display: 0.1 A
IMPORTANT
The drive will fault on an F007 “Motor Overload” if the value of this parameter is exceeded based on class 10 motor
overload protection according to NEC article 430 and motor over-temperature protection according to NEC article
430.126 (A) (2). UL 508C File 29572
To Next Page
Loading...
Need help?
General
