Rockwell Automation Allen-Bradley PowerFlex 520 Series - Feedback and Stop Mode Configuration

Rockwell Automation Publication 520-UM001K-EN-E - August 2021 253
Appendix J PowerFlex 525 PM Motor Configuration
Feedback
If you are configuring a closed loop PM motor control, key in the details of your
incremental encoder.
Stop Mode/Brake Type
Key in the details of your configuration.
IMPORTANT
Note the following:
• PowerFlex 525 drive only supports incremental AB encoder (25-ENC-1).
• Motor Feedback Type can be “Quadrature” or “Quad Check”.
• Only Interior Permanent magnet motor (iPM) is supported for closed loop
control.