Rockwell Automation Publication 520-UM001K-EN-E - August 2021 251
Appendix J
PowerFlex 525 PM Motor Configuration
This chapter contains instructions and diagrams on configuring the
PowerFlex 525 drive for use with a PM motor. For more information, see the
PowerFlex 525 Configuration with Permanent Magnet Motors Application
Technique, publication 520-AT001
.
To use PM motor control, you need to install the PowerFlex 525 drive firmware
revision 5.001 or later. If you wish to perform PM motor tuning by using the
PowerFlex 525 Startup Wizard in Connected Components Workbench
software, and update to the latest drive database.
Topic Page
Manual Configuration Using Drive Keypad 256
Additional PM Motor Configuration 257
Optional Parameter Adjustments for Optimum Performance 261
ATTENTION: It is the responsibility of the startup engineer / end user to use
proper safety precautions with any equipment used during this startup.
In no event will Rockwell Automation, Inc. be responsible or liable for indirect or
consequential damages resulting from the use or application of this equipment.
The examples and diagrams in this document are included solely for illustrative
purposes. Because of the many variables and requirements associated with
any particular installation, Rockwell Automation cannot assume responsibility
or liability of actual use based on the examples and diagrams.
No patent liability is assumed by Rockwell Automation, Inc. with respect to the
information, circuits, equipment. Or software described in this document.
Rockwell Automation reserves the right to make changes to this document
without prior notice. When using examples in this document the user
recognizes that Rockwell Automation cannot be made liable for any damage or
claims. Because there are many application-specific variables, users MUST
ensure that products are correctly used and the appropriate architecture is
deployed. Reproduction of the contents of this document, in whole or in part,
without written permission of Rockwell Automation, Inc. is prohibited.
To Next Page
Loading...
Need help?
General
