Rohde & Schwarz FSW Series - Page 119

Configuration
R&S
®
FSW-K7
119User Manual 1173.9240.02 ─ 17
If AC is selected, the frequency offset is automatically corrected, i.e. the trace is
always symmetric with respect to the zero line.
●
PM time evaluation
If DC is selected, the phase runs according to the existing frequency offset. In addi-
tion, the DC signal contains a phase offset of ± π.
If AC is selected, the frequency offset and phase offset are automatically corrected,
i.e. the trace is always symmetric with respect to the zero line.
Remote command:
[SENSe:]ADEMod<n>:AF:COUPling on page 255
Deviation
Switches between logarithmic and linear display of the modulation depth or the phase
deviation or the frequency deviation.
Remote command:
DISPlay[:WINDow<n>]:TRACe:Y:SPACing on page 239
AF Auto Scale
Activates automatic scaling of the y-axis for AF measurements. RF power and RF
spectrum measurements are not affected by the auto-scaling.
Remote command:
[SENSe:]ADJust:SCALe:Y:AUTO[:CONTinuous] on page 269
5.8.4.2 RF Evaluation
These settings are only available for RF evaluations and the result summary.
Range..........................................................................................................................120
Ref Level Position....................................................................................................... 120
Auto Scale Once......................................................................................................... 120
Scaling........................................................................................................................ 120
Demodulation