Rohde & Schwarz FSW Series - Page 239

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
239User Manual 1173.9240.02 ─ 17
When the display update during remote control is off, this command has no immediate
effect.
Parameters:
<Mode> ABSolute
absolute scaling of the y-axis
RELative
relative scaling of the y-axis
*RST: ABSolute
Example:
DISP:TRAC:Y:MODE REL
Manual operation: See "Scaling" on page 120
DISPlay[:WINDow<n>]:TRACe:Y[:SCALe]:RPOSition <Position>
This command defines the vertical position of the reference level on the display grid.
The R&S FSW adjusts the scaling of the y-axis accordingly.
For measurements with the external generator (R&S FSW-B10) the command defines
the position of the reference value.
Parameters:
<Position> *RST: 100 PCT = AF spectrum display; 50 PCT = time
display
Example:
DISP:TRAC:Y:RPOS 50PCT
Usage: SCPI confirmed
Manual operation: See "Reference Position" on page 80
See "Reference Value Position" on page 118
See "Ref Level Position" on page 120
DISPlay[:WINDow<n>]:TRACe:Y:SPACing <ScalingType>
This command selects the scaling of the y-axis.
For AF spectrum displays, only the parameters "LINear" and "LOGarithmic" are permit-
ted.
Parameters:
<ScalingType> LOGarithmic
Logarithmic scaling.
LINear
Linear scaling in %.
LDB
Linear scaling in the specified unit.
PERCent
Linear scaling in %.
*RST: LOGarithmic
Configuring the Measurement