Rohde & Schwarz FSW Series - Page 262

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
262User Manual 1173.9240.02 ─ 17
Parameters:
<State> ON | OFF
*RST: OFF
Example:
FILT:CCIR:WEIG ON
Activates the weighted CCIR filter.
Manual operation: See "Weighting" on page 115
[SENSe:]FILTer<n>:CCIR:[:UNWeighted][:STATe] <State>
This command activates/deactivates the unweighted CCIR filter in the specified win-
dow.
For details on weighting filters see "Weighting" on page 115.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
FILT:CCIR:UNW ON
Activates the unweighted CCIR filter.
Manual operation: See "Weighting" on page 115
[SENSe:]FILTer<n>:CCIT <State>
This command activates/deactivates the CCITT (CCITT P.53) weighting filter for the
specified evaluation.
For details on weighting filters see "Weighting" on page 115.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
FILT:CCIT ON
Activates the CCITT weighting filter.
Manual operation: See "Weighting" on page 115
[SENSe:]FILTer<n>:DEMPhasis:TCONstant
This command selects the deemphasis for the specified evaluation.
For details on deemphasis refer to "Deemphasis" on page 116.
Parameters:
25 us | 50 us | 75 us | 750 us
*RST: 50 us
Example:
FILT:DEMP:TCON 750us
Selects the deemphasis for the demodulation bandwidth range
from 800 Hz to 4 MHz with a time constant of 750 µs.
Configuring the Measurement