Rohde & Schwarz FSW Series - 11.4.8.4 (Post-processing) AF Filters

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
261User Manual 1173.9240.02 ─ 17
11.4.8.4 (Post-processing) AF Filters
The AF filter reduces the evaluated bandwidth of the demodulated signal and can
define a weighting function. AF filters are only available for AM or FM time domain
evaluations.
[SENSe:]FILTer<n>:AWEighted[:STATe]..........................................................................261
[SENSe:]FILTer<n>:AOFF.............................................................................................. 261
[SENSe:]FILTer<n>:CCIR:WEIGhted[:STATe].................................................................. 261
[SENSe:]FILTer<n>:CCIR:[:UNWeighted][:STATe]............................................................ 262
[SENSe:]FILTer<n>:CCIT............................................................................................... 262
[SENSe:]FILTer<n>:DEMPhasis:TCONstant.....................................................................262
[SENSe:]FILTer<n>:DEMPhasis[:STATe]......................................................................... 263
[SENSe:]FILTer<n>:HPASs:FREQuency[:ABSolute]..........................................................263
[SENSe:]FILTer<n>:HPASs:FREQuency:MANual............................................................. 263
[SENSe:]FILTer<n>:HPASs[:STATe]................................................................................264
[SENSe:]FILTer<n>:LPASs:FREQuency[:ABSolute].......................................................... 264
[SENSe:]FILTer<n>:LPASs:FREQuency:MANual..............................................................264
[SENSe:]FILTer<n>:LPASs:FREQuency:RELative............................................................ 264
[SENSe:]FILTer<n>:LPASs[:STATe]................................................................................ 265
[SENSe:]FILTer<n>:AWEighted[:STATe] <State>
This command activates/deactivates the "A" weighting filter for the specified evalua-
tion.
For details on weighting filters see "Weighting" on page 115.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
FILT:AWE ON
Activates the A weighting filter.
Manual operation: See "Weighting" on page 115
[SENSe:]FILTer<n>:AOFF
This command switches all AF filters for the selected evaluation off.
Usage:
Setting only
Manual operation: See "Deactivating all AF Filters" on page 116
[SENSe:]FILTer<n>:CCIR:WEIGhted[:STATe] <State>
This command activates/deactivates the weighted CCIR filter for the specified evalua-
tion.
For details on weighting filters see "Weighting" on page 115.
Configuring the Measurement