Instrument Functions
NRP2
147User Manual 1173.9140.02 ─ 07
Remote Interfaces
Fig. 4-72: Remote Interfaces dialog box
Select one of the available remote control interfaces or turn them off.
"Off"
Deactivates all remote control interfaces.
"GPIB"
Activates the GPIB interface for remote control via the IEC 625/IEEE
488 bus. See chapter 4.7.1.2, "GPIB settings", on page 148 for the
addressing.
"USB"
Activates the USB interface for remote control, see
chapter 4.7.1.3,
"USB settings", on page 148.
"VXI11"
Activates remote control via Ethernet using VXI-11 protocol, see
chapter 4.7.1.4, "VXI11 settings"
, on page 149 for information in
detail.
"Ethernet"
Activates remote control via
"Ethernet" using socket communication,
see chapter 4.7.1.5, "Raw Ethernet (socket communication) settings",
on page 150.
Command Set
Selects the instrument type whose remote command set is emulated by the
R&S
NRP2.
Note: The number of supported emulations is limited with the current firmware version
(V07.01).
Fig. 4-73: List of instruments emulated by the R&S
NRP2
The available instrument types are listed. This feature allows to replace a power meter
by an R&S NRP2 in existing test setups. Refer to Application Note 1G83 at the down-
load area of the product site on the Internet for details and up-to-date information
(http://www.rohde-schwarz.com/product/nrp2.html).
System settings
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
