Instrument Functions
NRP2
148User Manual 1173.9140.02 ─ 07
4.7.1.2 GPIB settings
Fig. 4-74: Remote Interfaces / GPIB
For configuring the R&S NRP2 for remote control using the GPIB interface, just enter
its GPIB address.
GPIB Address
Selects the address in the range 0 to 30 (factory preset is 20). The set GPIB address is
unchanged after a reset of the instrument settings.
Remote command:
SYSTem:COMMunicate:
GPIB[:SELF]:ADDRess on page 320
Command Set
Selects the instrument type for emulation, see "Command Set" on page 147.
4.7.1.3 USB settings
Remote control of the R&S NRP2 via the USB is performed according to the USBTMC
standard. For this purpose, a VISA library that supports remote control via the USB is
required by the remote-control computer.
Fig. 4-75: Remote Interfaces / USB
VISA Resource Identifier
Displays the VISA address string of the instrument. This identifier is automatically
assigned for remote control via USB, therefore the address cannot be configured for
remote control.
System settings
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
