Rohde & Schwarz NRP2 - Page 235

Remote Control - Commands
NRP2
232User Manual 1173.9140.02 ─ 07
Parameters:
<string> string
The *RST values depend on the selected channel:
CALC1:
MATH: "(SENS1)",
CALC2:
MATH: "(SENS2)",
CALC3:MATH: "(SENS3)",
CALC4:MATH: "(SENS4)",
CALC5:MATH: "(SENS1)",
...
CALC8:MATH: "(SENS1)".
CALCulate<[1]..8>:MATH[:EXPRession]:CATalog?
Lists all supported calculation functions. All functions are sent in the form of strings
which are allowed as parameters for the CALCulate<[1]..8>:
MATH:EXPRession
command.
Usage: Query only
CALCulate<[1]..8>:MAXimum:DATA?
CALCulate<[1]..8>:MINimum:DATA?
Queries the maximum/minimum of all measured values that previously occurred in this
calculate block.
The limit value is set to the current measured value when
●
the device is switched on
●
a reset is performed (*RST)
●
the value is explicitly set to the current measured value using the command
CALCulate[1..8]:
EXTRemes:
RESet.
The unit is the current unit of the measured result.
Possible Units: W | DBM | DBUV | DPCT | DB | O
Usage: Query only
CALCulate<[1]..8>:MEAN:DATA?
Queries the mean value of all measured values of the calculate block. The mean value
is reset when the auxiliary values are reset. The following formula applies:



N
i
i
x
N
x
1
1
Fig. 6-5: Mean value of all measured values
The unit is the current unit of the measured result.
Possible Units: W | DBM | DBUV | DPCT | DB | O
CALCulate (Configuration of Calculate Blocks)
北京海洋兴业科技股份有限公司（证券代码：839145）
电话：010-62176775
网址：www.hyxyyq.com