Remote Control - Commands
NRP2
254User Manual 1173.9140.02 ─ 07
Parameters:
<NRf> {, <NRf>} Enters offset values in the second column of the table selected
with MEM:
TABL:SEL
.
*RST: Tables are not changed in case of a *RST.
Default unit:
DB
MEMory:TABLe:GAIN:POINts?
Returns the number of entries (lines) in the table selected with MEM:TABL:SEL
<string>.
Usage: Query only
MEMory:TABLe:MAP <string>, 1...9
The numbers 0 to 9 are permanently assigned to the memory locations for device
states. Names (<string>) can be assigned to the numbers with MEM:TABL:MAP
. The
MEM:CLE[:NAME], MEM:TABL:MOVE and MEM:TABL:SEL commands expect these
names as parameters, not the numbers of the memory locations. By default the tables
are assigned the names "Table 1" to "Table 10". The name can contain the characters
"A" to "Z", "a" to "z", "0" to "9" and "_".
The query form of this command returns the number of the memory location with the
name <map>.
Parameters:
<string>, 1...9 maps the string on the selected memory locations for device
states.
MEMory:TABLe:MOVE <string>,<string>
This command allows tables to be renamed. The first parameter specifies the old
name, the second the new name. No data is copied, i.e. only the name of the table
changes.
Example:
MEM:TABL:MOVE "Table 1","Test setup"
Renames the table "Table 1" into "Test setup" .
Usage: Setting only
MEMory:TABLe:RESet
The command clears all tables for frequency dependent offset.
Usage: Event
MEMory:TABLe:SELect <name>
Selects a table.
MEMory
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
