Remote Control - Commands
NRP2
269User Manual 1173.9140.02 ─ 07
Parameters:
<state> ON | OFF
*
RST: OFF
[SENSe<[1]..4>]:CORRection:SPDevice:
SELect <NR1>
Several S-parameter tables can be stored in a sensor.
[SENSe<[1]..4>]:CORRection:
SPDevice:SELect selects one of these tables.
The [SENSe<[1]..4>]:CORRection:SPDevice:STATe ON command activates
measured-value correction.
Parameters:
<NR1> int_value
*RST: depending on sensor
[SENSe<[1]..4>]:CORRection:SPDevice:STATe <state>
Instructs the sensor to perform a measured-value correction by means of one of the
stored S-parameter tables (S-parameter device).
Parameters:
<state> ON | OFF
*RST: depending on sensor
[SENSe<[1]..4>]:FREQuency[:CW] <frequency>
[SENSe<[1]..4>]:FREQuency[:FIXed] <frequency>
Informs the R&S NRP2 about the frequency of the power to be measured since this
frequency is not automatically determined. The frequency is used to determine a fre-
quency-dependent correction factor for the measurement results.
Parameters:
<frequency> float_value
Range: depending on sensor
*RST: depending on sensor
Default unit:
HZ
[SENSe<[1]..4>]:FUNCtion[:ON] <mode>
Sets the sensor to the selected measurement mode.
In remote control, the timing (SENS:TIM:EXCL:
STAR and -:STOP) and the trigger
system of all measurement modes (except the Burst mode) are user-selectable.
Note:
SENSe (Sensor Commands)
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
