Annex
NRP2
403User Manual 1173.9140.02 ─ 07
E4418B/E4419B command Compatibility information
TRIGger[:SEQUence[1]|2]
The R&S NRP2 does not recognize the :SEQUence header and
uses no TRIGger command globally but only on a sensor-by-sensor
basis. If TRIGger or SENSe commands are to have a global effect,
the :ALL header must be used instead of the numeric suffix.
UNIT:POWer
The R&S NRP2 recognizes the units W, DBM and DBUV.
UNIT:POWer:RATio
The R&S NRP2 recognizes the units DB, DPCT and O.
:AC
Agilent recognizes the keyword :AC of some high-level commands
and SENSe
commands:
CONFigure
| READ | MEASure | FETCh
[:SCALar][:POWer:AC]
:RELative
:DIFFerence
:DIFFerence:RELative
:RATio
:RATio:RELative
SENSe:POWer:AC:RANGe:AUTO
The R&S NRP2 also recognizes these commands but :AVG should
be used instead of :AC since R&S NRP-Zxx Power Sensors sensors
eventually also measure DC components and the designation in the
R&S NRP2 is not used in the sense of SCPI.
Compatibility Information
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
