Rohde & Schwarz R&S ZNB - Page 10

Contents
R&S
®
ZNB/ZNBT
10User Manual 1173.9163.02 ─ 53
7.3.3 Initiating Measurements, Speed Considerations.........................................................728
7.3.4 Addressing Traces and Channels............................................................................... 729
7.4 Command Processing.............................................................................................. 730
7.4.1 Input Unit.....................................................................................................................730
7.4.2 Command Recognition................................................................................................731
7.4.3 Data Base and Instrument Hardware..........................................................................731
7.4.4 Status Reporting System............................................................................................ 732
7.4.5 Output Unit.................................................................................................................. 732
7.4.6 Command Sequence and Command Synchronization............................................... 732
7.5 Status Reporting System......................................................................................... 734
7.5.1 Overview of Status Registers......................................................................................735
7.5.2 Structure of an SCPI Status Register..........................................................................735
7.5.3 Contents of the Status Registers................................................................................ 737
7.5.4 Application of the Status Reporting System................................................................744
7.5.5 Reset Values of the Status Reporting System............................................................ 747
8 Command Reference......................................................................... 748
8.1 Special Terms and Notation..................................................................................... 748
8.1.1 Upper/Lower Case...................................................................................................... 749
8.1.2 Special Characters......................................................................................................749
8.1.3 Parameters..................................................................................................................749
8.1.4 Numeric Suffixes......................................................................................................... 749
8.2 Common Commands................................................................................................ 750
8.3 SCPI Command Reference.......................................................................................751
8.3.1 CALCulate Commands............................................................................................... 752
8.3.2 CONFigure Commands...............................................................................................948
8.3.3 CONTrol Commands...................................................................................................956
8.3.4 DIAGnostic Commands...............................................................................................980
8.3.5 DISPlay Commands....................................................................................................982
8.3.6 FORMat Commands................................................................................................. 1008
8.3.7 HCOPy Commands...................................................................................................1010
8.3.8 INITiate Commands.................................................................................................. 1015
8.3.9 INSTrument Commands............................................................................................1017
8.3.10 MEMory.....................................................................................................................1019