Rohde & Schwarz R&S ZNB - Page 11

Contents
R&S
®
ZNB/ZNBT
11User Manual 1173.9163.02 ─ 53
8.3.11 MMEMory Commands.............................................................................................. 1020
8.3.12 OUTPut Commands..................................................................................................1062
8.3.13 PROGram Commands.............................................................................................. 1067
8.3.14 [SENSe:] Commands................................................................................................ 1070
8.3.15 SOURce Commands.................................................................................................1205
8.3.16 STATus Commands...................................................................................................1253
8.3.17 SYSTem Commands.................................................................................................1256
8.3.18 TRACe Commands................................................................................................... 1298
8.3.19 TRIGger Commands................................................................................................. 1301
8.4 R&S ZVR/ZVABT Compatible Commands.............................................................1308
9 Programming Examples..................................................................1335
9.1 Basic Tasks..............................................................................................................1335
9.1.1 Typical Stages of a Remote Control Program...........................................................1335
9.1.2 Channel, Trace and Diagram Handling..................................................................... 1338
9.2 Condensed Programming Examples.................................................................... 1344
9.2.1 Path Independent RC Programs............................................................................... 1345
9.2.2 Trace and Diagram Handling.................................................................................... 1345
9.2.3 Using Markers........................................................................................................... 1354
9.2.4 Data Handling........................................................................................................... 1356
9.2.5 Calibration................................................................................................................. 1360
9.2.6 Mixer Measurement.................................................................................................. 1366
9.2.7 RFFE/GPIO Interface Programming......................................................................... 1369
9.2.8 Fixture Modeling........................................................................................................1371
10 Error Messages and Troubleshooting............................................1373
10.1 Errors during Firmware Operation........................................................................ 1373
10.1.1 Asynchronous Errors.................................................................................................1374
10.1.2 Errors during Measurement...................................................................................... 1374
10.2 Errors during Firmware Installation/Update......................................................... 1375
10.3 Collecting Information for Technical Support...................................................... 1377
10.4 Contacting Customer Support...............................................................................1378
11 Annexes............................................................................................ 1379
11.1 Administrative Tasks.............................................................................................. 1379