GUI Reference
R&S
®
ZNB/ZNBT
402User Manual 1173.9163.02 ─ 53
Tip: Overlapping limit line and ripple limit line segments are not displayed when a
point-based x-axis is active; see Chapter 5.4.1.1, "Rules for Limit Line Definition",
on page 135.
Remote command:
[SENSe<Ch>:]FREQuency:SEGMent:AXIS
6.10.2.2 Define Segments Dialog
The "Define Segments" dialog defines all channel settings for a Segmented frequency
sweep and imports or exports segmented sweep settings.
Access: CHANNEL – [SWEEP] > "Sweep Type" > "Define Segments..."
The dialog contains a table to edit the individual segments of the sweep range. Use the
Displayed Columns Dialog to select the columns to be displayed and edited.
●
Sweep segments are allowed to overlap.
●
In contrast to standard frequency sweeps, the start and stop frequency in a sweep
segment must not be different.
So with a segmented sweep you can measure n
1
points at frequency f
1
(in segment
1), n
2
points at frequency f
2
(in segment 2) etc.
Sweep Softtool
To Next Page
Loading...
