GUI Reference
R&S
®
ZNB/ZNBT
615User Manual 1173.9163.02 ─ 53
The "TDR Setup" contains the following sections/controls:
●
"Topology"
Opens the "Balanced Ports" dialog that allows to configure the logical DUT ports
(see Chapter 6.2.1.3, "Balanced Ports Dialog", on page 256)
●
"Stimulus..."
Opens the TDR Stimulus Settings Dialog that allows to configure the frequency
sweep whose results are then used for the time domain transformation
●
"Calibration"
The "Calibration" section provides easy access to (basic) manual and automatic
calibration functions (see Chapter 6.11.1, "Start Cal Tab", on page 416)
●
"Stimulus"
The "Stimulus" section provides quick access to settings that are also available in
the TDR Stimulus Settings Dialog. These settings are only available in Automatic
Harmonic Grid mode, which is activated automatically when opening the "TDR
Stimulus Settings" dialog.
6.15.2.2 TDR Stimulus Settings Dialog
This dialog allows you to configure the frequency sweep whose results are then used
for the time domain transformation and subsequent TDR simulation.
Access: SYSTEM – [APPLIC] > "TDR" > "TDR Setup" > "Stimulus..."
After the settings are made, the resulting sweep parameters are shown in the lower
part of the dialog, as can be seen in the screenshot below.
Opening the dialog automatically activates the Automatic Harmonic Grid function.
Applic Softtool
To Next Page
Loading...
