Rohde & Schwarz R&S ZNB - Page 949

Command Reference
R&S
®
ZNB/ZNBT
949User Manual 1173.9163.02 ─ 53
CONFigure:CHANnel:CATalog?.......................................................................................949
CONFigure:CHANnel:MEASure:ALL[:STATe].................................................................... 949
CONFigure:CHANnel<Ch>[:STATe]..................................................................................950
CONFigure:CHANnel<Ch>:MEASure[:STATe]...................................................................950
CONFigure:CHANnel<Ch>:NAME................................................................................... 951
CONFigure:CHANnel<Ch>:NAME:ID?............................................................................. 951
CONFigure:CHANnel<Ch>:TRACe:REName.................................................................... 951
CONFigure:CHANnel<Ch>:TRACe:CATalog?................................................................... 952
CONFigure:TRACe:CATalog?..........................................................................................952
CONFigure:TRACe:WINDow?.........................................................................................953
CONFigure:TRACe:WINDow:TRACe?............................................................................. 953
CONFigure:TRACe<Trc>:CHANnel:NAME?......................................................................954
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?................................................................. 954
CONFigure:TRACe<Trc>:NAME......................................................................................955
CONFigure:TRACe<Trc>:NAME:ID?................................................................................955
CONFigure:TRACe<Trc>:REName.................................................................................. 955
CONFigure:CHANnel:CATalog?
Returns the numbers and names of all channels in the current recall set. The response
is a string containing a comma-separated list of channel numbers and names; see
example below. If all channels have been deleted the response is an empty string ("").
Example:
*RST; :CONF:CHAN2:STAT ON; NAME 'New Channel'
Create channel 2 and assign the channel name "New Channel".
CONF:CHAN:CAT?
Query all channels and their names. As a default channel no. 1
is created on *RST, the response is
'1,Ch1,2,New_Channel'.
CONF:CHAN:NAME:ID? 'New Channel'
Query the channel number for the channel named "New Chan-
nel". The response is 2.
Usage: Query only
Manual operation: See "Channel table" on page 507
CONFigure:CHANnel:MEASure:ALL[:STATe] <Boolean>
Enables or disables the sweep in all channels of the active recall set. This command
can be used in combination with CONFigure:CHANnel<Ch>:MEASure[:STATe] to
optimize the measurement speed.
Parameters:
<Boolean> ON | OFF
*RST: ON
Example: See CONFigure:CHANnel<Ch>:MEASure[:STATe]
Manual operation: See "Continuous / Single" on page 413
SCPI Command Reference