SMIQ Digital Standard PDC
1125.5555.03 E-92.289
FREQ
100. 000 000 0
MHz
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
PHS
PHS
IS95
NADC
PDC
GSM
TRIGGER MODE
EXECUTE TRIG
TRIGGER....
CLOCK...
POWER RAMP C>
SLOT ATTENUA
SAVE/RCL FRA
GET PREDEFINED FRAME
...
RECALL FRAME...
SAVE FRAME...
DELETE FRAME...
LEVEL
-30.0
dBm
PEP
-27.5
dBm
SYNC
DN
12
Fig. 2-190 Menu DIGITAL STD - PDC - SAVE/RCL FRAME, SMIQ equipped with Modulation Coder
SMIQB20 and Data Generator SMIQB11
(SAVE/RCL FRAME...) GET PREDEFINED
FRAME...
Loads a factory-set frame configuration.
DN_TCH Downlink traffic channels in all slots.
UP0_TCH Uplink traffic channels in slot 0
IEEE
:SOUR:PDC:FLIS:PRED:LOAD "dn_tch"
RECALL FRAME...
Loads a frame configuration saved by the user.
IEC/IEEE-bus
:SOUR:PDC:FLIS:LOAD "name"
SAVE FRAME...
Saves a user-defined frame configuration.
IEC/IEEE-bus
:SOUR:PDC:FLIS:STOR "name"
DELETE FRAME...
Deletes a frame configuration saved by the user.
IEC/IEEE-bus
:SOUR:PDC:FLIS:DEL "name"
LINK DIRECTION
Selection between UPLINK and DOWNLINK. Depending on the selection,
different burst types are offered under SELECT SLOT.
IEC/IEEE-bus command
:SOUR:PDC:LINK UP
To Next Page
Loading...
