Digital Standard GSM/EDGE SMIQ
1125.5555.03 2.316 E-9
Selection: BURST TYPE = EDGE
Fig. 2-204 Menu DIGITAL STD - GSM/EDGE - SELECT SLOT – EDGE, SMIQ equipped with
Modulation Coder SMIQB20 and Data Generator SMIQB11
(SELECT SLOT...)
EDGE
BURST TYPE
Opens a window for selecting the burst type to be used for
configuring the selected slot.
EDGE EDGE Normal Burst
IEC/IEEE bus
:SOUR:GSM:SLOT2:TYPE EDGE
SLOT LEVEL
Selection of the level for the selected slot.
OFF Maximum attenuation
IEC/IEEE bus
:SOUR:GSM:SLOT2:LEV OFF
FULL The level is the same as that indicated in the
LEVEL display of SMIQ.
IEC/IEEE bus
:SOUR:GSM:SLOT2:LEV FULL
ATTEN The level is reduced by the value set under
SLOT ATTENUATION.
IEC/IEEE bus
:SOUR:GSM:SLOT2:LEV ATT
SET DEFAULT
Resets the following parameters to the factory-selected values.
IEC/IEEE bus command
:SOUR:GSM:SLOT1:PRES
HOP TRIGGER
Switches the HOP trigger signal on or off. When set to ON, a
HOP signal is generated at the end of the selected slot. The
signal is available at the HOP output of the PARDATA
connector. It may be used for implementing frequency
hopping in the LIST MODE (see section "List Mode").
IEC/IEEE-bus
:SOUR:GSM:SLOT1:HOPP:TRIG
TAIL
Display of data contents in the 9-bit data field "Tail". The tail
bits are permanently set to 111111111 in line with the GSM
standard.
To Next Page
Loading...
