Roland BK-9 - MIC Settings; One Touch Hold; Performance Hold; Pedal Switch and Pedal Control

Menu options
144
Mic Settings
This page can be selected using [MENU] button  “Global”  “MIC
Settings”.
Right Display
The BK-9 provides an equalizer you can set for the MIC IN input.
Parameter Setting Explanation
Eq Low Freq
50 Hz, 80 Hz, 100
Hz, 150 Hz, 200
Hz, 250 Hz, 300 Hz,
400 Hz
Frequency of the low range you wish to
boost or cut.
Eq Low Gain -15 db~0~+15 db
Gain of the low range. Negative values
reduce the level
Eq High Freq
2000 Hz, 3000 Hz,
4000 Hz, 5000 Hz,
6000 Hz, 7000 Hz,
8000 Hz, 9000 Hz,
10000 Hz, 11000
Hz, 12000 Hz,
Frequency of the high range you wish
to boost or cut.
Eq High Gain -15 db~0~+15 db
Gain of the high range. Negative values
reduce the level.
One Touch Hold
This parameter can be selected using [MENU] button  “Global” 
“One Touch Hold”.
Right Display
The parameters on this page allow you to lter certain “One Touch”
settings. Select “On” for the settings you do not want to load along
with the remaining One Touch settings when you press a ONE
TOUCH button.
Parameter Setting
Tempo O, On
Tone Part* O, On
Intro/Ending O, On
Variation O, On
Expression Pedal O, On
Assign Switches O, On
DBeam O, On
Bass Inversion O, On
Parameter Setting
Scale Tune O, On
[*] This parameter lters also the “Lower Hold” parameter (p. 136).
Performance Hold
This page can be selected using [MENU] button  “Global” 
“Performance Hold”.
Right Display
The parameters on this page allow you to lter certain Performance
settings. Select “On” for the settings you do not want to load
along with the remaining settings when you select a Performance
memory.
Parameter Setting
Rhythm* O, On
Tempo* O, On
Expression Pedal O, On
Assign Switches O, On
DBeam O, On
Tone*
1
O, On
Tone Part*
2
O, On
Split O, On
Lower Octave O, On
Arr. Type O, On
Key* O, On
MIDI Set O, On
Bass Inversion O, On
Scale Tune O, On
[*
1
] These parameters can also be switched by pressing and holding
the assigned buttons on the front panel.
[*
2
] This parameter lters also the “Lower Hold” parameter (p. 136).
Pedal Switch and Pedal Control
You can connect two types of Pedal Switch to the BK-9’s PEDAL
CONTROL jack (Not Continuous or Continuos).
The “Not Continuous” pedal (e. g. DP-2) has only two states: O and
On.
The “Continuous” pedal (e. g. DP-10) has more states between On/
o.
The BK-9 recognizes the type of pedal switch you connect to the
PEDAL CONTROL jack:
Pedal Switch Jack Type How BK-9 recognize the pedal switch
Mono Type: Not Continuous
Stereo Type: Continuous