Roland BK-9 - Track Exchange; Editing Song Using Micro Edit

Editing Song using Micro Edit
91
parameters are displayed also.
Parameter Setting Explanation
From CC 0~127
It allows you to set the lower limit of the
control change numbers or values to be
copied within the specied “From”/“To”
time range.
To CC 0~127
This parameter allows you to set the
upper limit of the control change
numbers or values to be copied within
the specied “From”/“To” time range.
TRACK EXCHANGE
TRACK EXCHANGE allows you to move the data of the source track
(left) to the destination track (right) and –at the same time– the
data of the destination track to the source track.
Left Display Right Display
Parameter Setting Explanation
Source Track Trk 1~ Trk 16
This is where you select the rst track to
be exchanged.
Dest Trk
Trk 1~ Trk 16
(except the track
selected as
“Source Trk”)
This is where you select the second track
to be exchanged.
NOTE
Be careful when exchanging a drum
track and a “melodic” track. The result
may not be what you had in mind.
Editing Song using Micro Edit
Select this mode whenever you only need to change small details
of an otherwise perfect Standard MIDI File.
In this section, we will use the word “event” for any kind of message.
You can only view and edit one track at a time.
1. Load the song you wish to edit (if it does not yet reside in
the BK-9’s Song internal memory).
See “Selecting a Song or Rhythm on a USB Memory” (p. 44).
2. Press the [MENU] button, rotate the dial to select “16Track
Sequencer”, then push the dial.
3. Press the [QUICK MENU] button.
The left display changes to:
Left Display
4. Use the dial to select “Micro Edit”.
The displays change to:
Left Display Right Display
5. In the left display use the dial to select the track you want
to edit.
The right display shows you the events of the selected track.
6. In the right display rotate the dial to scroll the events list.
7. Push the dial several times until the desired eld is
selected.
The selected eld is shown in reverse.
Right Display
In the example we selected a “Note” event.
8. Rotate the dial to change the value (In the example the
note number).
9. Push the dial several times until the eld is deselected.
The display shows the led deselect:
Right Display