Assign Switches [S1], [S2], [S3], [S4]
53
If you want you can change the Melody Intelligent Parameters:
2. Press [MENU] button “Performance Edit” “Melody
Intelligent”
For more information about Melody Intelligent Parameters see p.
141.
TIPS
You can also select the Melody Intelligent Parameters page by
pressing and holding [MELODY INTELL]
3. Press the [MELODY INTELL] button again (its indicator
goes dark) to switch o the counter-melody.
Assign Switches [S1], [S2], [S3], [S4]
The Assign Switch buttons allow you to quickly access a function
you would normally select via the display (which may involve
several steps).
How to Assign a Function
You can assign functions to these buttons.
1. Press [MENU] button “Performance Edit” “Assign
Switch”
Right Display
2. Select the “Switch 1/2/3/4” and assign the desired
function. See “Browsing Windows and Setting Parameter
Values” (p. 26).
For the list of functions see “Assign Switches” (p. 139).
How to Recall the Assigned Functions
1. Press the [S1], [S2], [S3] or [S4] button to recall the
assigned function.
Using the Assign Switches with
SuperNATURAL Tones.
Each SuperNATURAL instrument provides eective performance
variation sounds; you can use [S1] and [S2] (default) to instantly
switch between them as you play.
For the list of variation sounds please see the “Tone & Drum Kit List“.
You can download it from http://www.roland.com/manuals.
MEMO
As default [S1] and [S2] button are assigned to “SN Variation 1 “
and “SN Variation 2“.
Using the D-BEAM Controller
The D-BEAM Controller allows you to control various aspects of
your performance or to add something to the music, by moving
your hand, head, etc., in the air. You only need to make sure that
you do so over the two “eyes” and within a 40 cm (±16”) range. Your
movements are translated into musical expression.
1. Press the D-BEAM button that is assigned to the function
you wish to use. For example [DJ GEAR].
This switches on the D-BEAM controller.
2. Start playback of a Rhythm (p. 38) or Song (p. 45).
To Next Page
Loading...
