Roland BK-9 - What a One Touch Memory Saves

Programming Your Own ONE TOUCH Settings (One Touch Edit)
43
Right Display
(Here, ONE TOUCH memory 2 has been selected for editing.)
MEMO
You can also select the desired ONE TOUCH using the dial.
4. Change the required settings.
As soon as you change any setting, the display alerts you to the fact
that the contents of the selected memory no longer corresponds to
the current settings (“EDITED”):
Right Display
5. Rotate the dial to select the ONE TOUCH memory where
you want to save your new settings.
6. Press the [WRITE] button.
The display changes to:
Right Display
NOTE
The above message is only displayed the rst time you press
[WRITE] after editing a ONE TOUCH memory.
7. To save your ONE TOUCH changes, use the dial to select
“Yes” and press it to conrm.
The display shows the “Executing” message and then “Operation
Complete”.
Select “No” and press [ENTER] if you don’t want to save your
changes after all.
 If the “My Rhythms” folder on the USB memory already
contains a rhythm le of the same name…
In that case, the display shows the following message when you
select “Yes” and push the dial (see above):
Right Display
What a One Touch memory saves
Group Parameters Parameter
Front Panel (button status)
• VARIATION [1], [2], [3], [4]
• [AUTO FILL IN]
• [INTRO/ENDING]
• [SYNC START]
• [SPLIT]
• [MELODY INTELL]
‘Performance Edit’ ’Tone Part View’ (p. 127).
All except for “Key Touch“
‘Performance Edit’ ’Tone Part Eects’ (p. 131).
All
‘Performance Edit’ ’Split’ (p. 136).
“Lower Old” only
‘Performance Edit’ ’Arranger Setting’ (p. 137).
• Zone
• Type
‘Performance Edit’ ’Melody Intelligent’ (p. 141).
All
‘Performance Edit’ ’Assign Switches’ (p. 139).
All
‘Performance Edit’ ’Scale Tune Switch’ (p. 140).
All
‘Performance Edit’ ’Scale Tune’ (p. 140).
All
‘Performance Edit’ ’D Beam’ (p. 53).
All
SPECIAL BEHAVIOUR of the INTRO Division
Whatever the status (O, On) of the INTRO division saved in a
One Touch is, if you recall the One Touch memory while no
Rhythm is played back, the INTRO division is always set On.