Roland BK-9 - Edit Song Parts; Edit System; Edit Tone Parts; Sync

Menu options
154
Parameter Setting Explanation
Select All O, On
Select “On” to receive all MIDI message listed
above.
* This parameter is available for Tone and Song parts only.
Edit Tone Parts
The following parameters are located on the display page that can
be selected using [MENU] button “MIDI” “Edit Tone Parts”.
Right Display
1. Use the dial to select the tone part (rst row) you want to
edit (Upper1, Upper2, Lower, M.Bass, Mel.Intell).
The display now shows the settings for the selected part.
Parameter Setting and Explanation
Tx
For the explanation of these
parameters please refer to page
152.
Tx Ch
Tx Shift
Tx Local
Tx Event
Rx
For the explanation of these
parameters please refer to page
153.
Rx Ch
Rx Shift
Rx Limit Low/High
Rx Event
Edit Song Parts
The following parameters are located on the display page that can
be selected using [MENU] button “MIDI” “Edit Song Parts”.
Right Display
1. Use the dial to select the song part (rst row) you want to
edit (1~16).
The display now shows the settings for the selected part.
Parameter Setting and Explanation
Tx
For the explanation of these
parameters please refer to page
152.
Tx Ch
Tx Shift
Tx Local
Tx Event
Rx
For the explanation of these
parameters please refer to page
153.
Rx Ch
Rx Shift
Rx Limit Low/High
Rx Event
Edit System
The following parameters are located on the display page that can
be selected using [MENU] button “MIDI” “Edit System”.
Right Display
The “Edit System” group contains the following parameters:
Edit System Explanation
Sync
These parameters are used to synchronize
external MIDI devices. See below.
Basic
The parameters of this group aect the BK-9’s
Basic channel. The Basic channel is used to receive
and transmit Program Change and Bank Select
messages for selecting Performances as well as for
the reception and transmission of other kinds of
messages that are not directly related to a specic
MIDI channel. See p. 155.
Rhythm
The parameters of this group aect the BK-9’s
Rhythm channel. The Rhythm channel is used for
receiving program change and bank select mes-
sages that select rhythm and volume messages
that change the rhythm’s volume. See p. 156.
NTA
These parameters allow you to assign MIDI chan-
nels to the BK-9’s NTA parts (Notet-to-Arranger).
Only notes received on one of these channels are
considered chord information that can be used
to transpose rhythm playback in real-time. See
p. 157.
Parameters
This group contains MIDI parameters that are not
related to the previous groups. See p. 157.
Visual Control TxCh
Allows you to set the MIDI transmit channel for
the Visual Control function. (The BK-9 does not
receive Visual Control messages). See p. 158
Sync
The following parameters are located on the display page that can
be selected using [MENU] button“MIDI”  “Edit System” “Sync”.