Roland BK-9 - Loading a Chords Sequence

Recording a Chord Sequence (Chord Loop)
80
Right Display
2. Press the [QUICK MENU] button to enter in the Chord
Loop Edit” page.
Left Display
3. Rotate the dial to select “Save” and push the dial.
The display now shows the contents of the connected USB memory.
Select the location to save the le
NOTE
Your own chords sequence can only be saved to a USB memory.
If you forgot to connect one, the display now shows the
message “USB Device not inserted”.
4. Press the [WRITE] button
The BK-9 suggests the name “Chord Sequence”.
Right Display
.
5. Use the dial and the TONE [0]~[9] buttons to enter the
desired name. See “How to type a name in BK-9” (p. 27).
6. Press the [WRITE] button to conrm your desire to save
the chords sequence.
The display briey conrms the operation and then returns to the
“Chord Loop” page.
If the USB memory already contains a rhythm le of the specied
name, you will be asked whether you want to overwrite it:
Right Display
In this case, select “YES” using the dial to replace the old le with the
new one (the old le will be lost). Otherwise, select “NO”.
Loading a Chords Sequence
You can load a chords sequence previously saved.
1. Press the [MENU] button and using the dial to select the
“Cord Loop“ page.
You can also select the “Chord Loop” page by pressing and hold the
CHORD LOOP [REC].
2. Press the [QUICK MENU] button to enter in the Chord
Loop Edit” page.
3. Rotate the dial to select “Load” and push the dial.
The display now shows the contents of the connected USB memory.
4. Use the dial to select the chords sequence le to load and
push the dial. For example “Chord Sequence.CSQ”.
The display briey conrms the operation and then returns to the
“Chord Loop” page.
MEMO
The chord sequence les have the extension “.CSQ“