Roland JD-XA - DELAY Edit

24
Eects
DELAY Edit
Menu
[Shift] +Cursor [
K
] [
J
]
Parameter
Cursor [
K
] [
J
]
Value
Value [-] [+]
Explanation
DELAY
(Delay)
Level
(Delay Level)
0–127 Adjusts the volume of delay sound.
Switch
(Delay Switch)
OFF, ON Switches the delay on/o.
Sync
(Delay Sync)
msec, NOTE
If this is set to “msec,” you can specify the DELAY Time in msec units.
If this is set to “NOTE,” you can specify the DELAY Note in terms of a note value relative to the
tempo.
If Fx TempoSync is “ON,” this indicates (NOTE), and operation is the same as when “NOTE” is
specied.
Time
(Delay Time)
*
This is valid only if “msec” is
selected for Delay Sync.
0–1300 ms (msec)
Delay time from when the original sound is heard to when the delay sound is heard
Note
(Delay Note)
*
This is valid only if “NOTE” is
selected for Delay Sync.
1/64T, 1/64, 1/32T, 1/32,
1/16T, 1/32., 1/16, 1/8T,
1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1/1T, 1/2.,
1/1, 2/1T, 1/1., 2/1
Acceleration
(Delay Acceleration)
0–15
Speed at which the current delay time changes to the specied delay time when you change
the delay time. The rate of change for the Delay Time directly aects the rate of pitch change.
Feedback
(Delay Feedback)
-98%–0–+98%
Adjusts the amount of the delay sound that’s fed back into the eect.
Negative (-) values invert the phase.
HF Damp
(Delay HF Damp)
200 Hz, 250 Hz, 315 Hz,
400 Hz, 500 Hz, 630 Hz,
800 Hz, 1000 Hz, 1250
Hz, 1600 Hz, 2000 Hz,
2500 Hz, 3150 Hz, 4000
Hz, 5000 Hz, 6300 Hz,
8000 Hz, BYPASS
Adjusts the frequency above which sound fed back to the eect is ltered out.
If you do not want to lter out any high frequencies, set this parameter to BYPASS.
Low Gain
(Delay Low Gain)
-15 dB–0–+15 dB Amount of low-range boost/cut
High Gain
(Delay High Gain)
-15 dB–0–+15 dB Amount of high-range boost/cut