Roland JD-XA - COMBINATION 56: Ampsim->Dly (Guitar Amp Sim 0 Delay)

48
Eects
56: AmpSim->Dly
(Guitar Amp Sim 0 Delay)
Balance W
Balance D
L in
R in
L out
R out
Pre Amp
Speaker
Feedback
Delay
Balance W
Balance D
Parameter Value Explanation
Pre Amp Sw OFF, ON Turns the amp switch on/o.
Type
Type of guitar
amp
JC-120, CLEAN TWIN, MATCHDRIVE,
BG LEAD, MS1959I, MS1959II,
MS1959I+II, SLDN LEAD, METAL5150,
METAL LEAD, OD-1, OD-2 TURBO,
DISTORTION, FUZZ
Volume # 0–127
Volume and amount of distortion
of the amp
Master # 0–127 Volume of the entire pre-amp
Gain
LOW, MIDDLE,
HIGH
Amount of pre-amp distortion
Bass 0–127
Tone of the bass/mid/treble
frequency range
* Middle cannot be set if
“MATCHDRIVE” is selected as
the Type.
Middle 0–127
Treble 0–127
Speaker Sw
(Speaker Switch)
OFF, ON
Selects whether the sound will be
sent through the speaker simulation
(ON) or not (OFF)
SpType
(Speaker Type)
(See the following
table)
Type of speaker
Dly Switch #
(Delay Switch)
OFF, ON Delay on/o
Dly Time #
(Delay Time)
0–1300 ms
Adjusts the delay time from the
direct sound until the delay sound
is heard.
DlyFeedback #
(Delay Feedback)
-98–+98%
Adjusts the proportion of the delay
sound that is fed back into the
eect.
Negative (-) values invert the phase.
D HF Damp
(Delay HF Damp)
200–8000 Hz,
BYPASS
Frequency at which the high-
frequency content of the delayed
sound will be cut
(BYPASS: no cut)
Dly Bal #
(Delay Balance)
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the delay (W) and the
sound that is not sent through the
delay (D).
Level 0–127 Output volume
Specications of each Speaker Type
The speaker column indicates the diameter of each speaker unit
(in inches) and the number of units.
Type Cabinet Speaker Microphone
SMALL 1 Small open-back enclosure 10 Dynamic
SMALL 2 Small open-back enclosure 10 Dynamic
MIDDLE Open back enclosure 12 x 1 Dynamic
JC-120 Open back enclosure 12 x 2 Dynamic
BUILT-IN 1 Open back enclosure 12 x 2 Dynamic
BUILT-IN 2 Open back enclosure 12 x 2 Condenser
BUILT-IN 3 Open back enclosure 12 x 2 Condenser
BUILT-IN 4 Open back enclosure 12 x 2 Condenser
BUILT-IN 5 Open back enclosure 12 x 2 Condenser
BG STACK 1 Sealed enclosure 12 x 2 Condenser
BG STACK 2 Large sealed enclosure 12 x 2 Condenser
MS STACK 1 Large sealed enclosure 12 x 4 Condenser
MS STACK 2 Large sealed enclosure 12 x 4 Condenser
METAL STACK Large double stack 12 x 4 Condenser
2-STACK Large double stack 12 x 4 Condenser
3-STACK Large triple stack 12 x 4 Condenser