Roland JD-XA - Trigger Mode

58
MIDI Control
Section
Parameter
Cursor [
K
] [
J
]
Value
Value [-] [+]
Explanation
MIDI CTRL
(MIDI Control)
A-OSC1
CC01-CC31
CC33-CC127
BEND
AFT
Specify the MIDI message that is assigned to each knob or slider.
A-OSC2
AUX
HPF
Drive
Cuto
Resonance
Key Follow
Filt Env
Filt A
Filt D
Filt S
Filt R
Amp Level
Amp A
Amp D
Amp S
Amp R
Portamento
Trigger Mode
You can assign MIDI messages to the [01]–[16] buttons so that the assigned MIDI message is transmitted from the MIDI OUT connector or USB MIDI
OUT when you press the corresponding button. These messages are not transmitted to the internal sound engine or to the sequencer.
1. Hold down the [Shift] button and press the [MIDI CTRL] button.
The Program No. display changes to “
TrG
,” trigger mode turns on, and the trigger mode parameters appear.
2. When you press the [01]–[16] buttons, the assigned MIDI messages are transmitted.
They are transmitted on the channel of the currently selected part.
* To turn trigger mode o, hold down the [Shift] button and press the [MIDI CTRL] button once again.
MEMO
If trigger mode is on but the trigger mode parameters are not shown, hold down the [Exit] button and press one of the [01]–[16] buttons to see
the trigger mode parameters.
Button
[01]–[16]
Parameter
Cursor [
K
] [
J
]
Value
Value [-] [+]
Explanation
[01]–[16]
Assign
When you change the value, you’ll be able to edit any related values.
NOTE
Number: Note number
Velocity: Velocity
CC
Number: Control change number
On Value: Value when button is turned on
O Value: Value when button is turned o
BEND-DOWN
Outputs a pitch bend message.
BEND-UP
AFT Outputs a channel pressure message.
PC+BS
MSB: Bank select MSB
LSB: Bank select LSB
PC: Program change
Type (*)
MOMENTARY
Remains on while you hold down the button.
Turns o when you release the button.
LATCH The setting is turned on/o each time you press the button.
* Available if Assign is NOTE, CC, BEND-DOWN,BEND-UP, or AFT.