Roland JD-XA - Dist->Dly (Distortion 0 Delay); Dist->Flg (Distortion 0 Flanger)

43
Eects
49: Dist->Flg
(Distortion 0 Flanger)
L in
R in
Flanger
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
Parameter Value Explanation
Dist Drive #
(Distortion Drive)
0–127
Degree of distortion
Also changes the volume.
Dist Pan #
(Distortion Pan)
L64–63R
Stereo location of the distortion
sound
Flg PreDly
(Flanger Pre Delay)
0.0–100.0 ms
Adjusts the delay time from the
direct sound until the anger sound
is heard.
Flg Sync
(Flanger Sync)
Hz, NOTE
Hz: The Flg Rate value is specied
in Hz.
NOTE: The Flg Rate value is specied
as a note value.
Flg Rate #
(Flanger Rate)
0.05–10.00 Hz,
note
Rate of modulation
Flg Depth
(Flanger Depth)
0–127 Depth of modulation
FlgFeedback #
(Flanger Feedback)
-98–+98%
Adjusts the proportion of the anger
sound that is fed back into the
eect.
Negative (-) values invert the phase.
Flg Bal #
(Flanger Balance)
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the anger (W) and the
sound that is not sent through the
anger (D).
Level 0–127 Output volume
50: Dist->Dly
(Distortion 0 Delay)
L in
R in
Delay
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
Parameter Value Explanation
Dist Drive #
(Distortion Drive)
0–127
Degree of distortion
Also changes the volume.
Dist Pan #
(Distortion Pan)
L64–63R
Stereo location of the distortion
sound
Delay Sync msec, Note
msec: The Dly Time/Note value is
specied in msec.
NOTE: The Dly Time/Note value is
specied as a note value.
Dly Time/Note
(Delay Time/Note)
0–2600 ms, note
Adjusts the delay time from the
direct sound until the delay sound
is heard.
DlyFeedback #
(Delay Feedback)
-98–+98%
Adjusts the proportion of the delay
sound that is fed back into the
eect.
Negative (-) values invert the phase.
D HF Damp
200–8000 Hz,
BYPASS
Adjusts the frequency above which
sound fed back to the eect will
be cut.
If you do not want to cut the high
frequencies, set this parameter to
BYPASS.
Dly Bal #
(Delay Balance)
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the delay (W) and the
sound that is not sent through the
delay (D).
Level 0–127 Output volume