Roland JD-XA - MIC; MIC Edit

55
Mic
Mic Edit
1. Press the [Menu] button.
2. Use the cursor [
K
] [
J
] buttons to select “MIC EDIT” and press the [Enter] button.
Menu
[Shift] + Cursor [
K
] [
J
]
Parameter
Cursor [
K
] [
J
]
Value
Value [-] [+]
Explanation
MIC
(Microphone)
Phantom Sw
(Mic Phantom Switch)
OFF, ON
If you’re using a condenser mic, connect it via the balanced (XLR) plug and turn this “ON”
(phantom power is not supplied to the 1/4” plug).
If you’re using a dynamic mic, turn this “OFF.”
* You must leave phantom power turned o unless you have connected a condenser mic
that requires a phantom power supply. Supplying phantom power to a dynamic mic or an
audio playback device can cause malfunctions. For details on mic specications, refer to the
owner’s manual of the mic you’re using. (This unit’s phantom power supply provides DC 48 V,
10 mA maximum.)
MEMO
Phantom power settings are not memorized by the unit. When you turn o the power, the phantom power
returns to “OFF.”
Level
(Mic Level)
0–127 Adjusts the mic input level.
Mode
(Mic Mode)
Species the MIC mode.
OFF The mic is not used.
VOCODER The vocoder is used.
MOD
This is a mic modulation function that lets you use your voice to apply change to the sounds
you’re playing. Changes in the volume of your voice can vary a parameter of the synthesizer’s
analog part.
BYPASS The voice being input to the mic is output without change.
MIC VOCODER edit (if “VOCODER” is selected as the MIC Mode)
Menu
[Shift] + Cursor [
K
] [
J
]
Parameter
Cursor [
K
] [
J
]
Value
Value [-] [+]
Explanation
MIC VOCODER
(Mic Vocoder)
Rev Send
(Reverb Send Level)
0–127 Adjusts the amount of reverb for the sound that passes through vocoder.
Envelope
(Vocoder Envelope)
Selects the type of vocalization.
SHARP The human voice is emphasized.
SOFT The instrumental sound is emphasized.
LONG A vintage sound with a long decay is produced.
Mic Sens
(Mic Sensitivity)
0–127 Species the input sensitivity of the mic.
Synth Level
(Vocoder Synth Level)
0–127 Species the input level of the instrumental sound.
Mic Mix
(Vocoder Mic Mix Level)
0–127
Species the amount of mic sound passing through the Mic HPF (Mic High Pass Filter) that is
added to the output of the vocoder.
Mic HPF
(Mic High Pass Filter)
BYPASS, 1000 Hz,
1250 Hz, 1600 Hz,
2000 Hz, 2500 Hz,
3150 Hz, 4000 Hz,
5000 Hz, 6300 Hz,
8000 Hz, 10000 Hz,
12500 Hz, 16000 Hz
Species the frequency at which the high-pass lter (HPF) applied to the mic sound starts to
take eect.
This does nothing if BYPASS is specied.
Level
(Mic Vocoder Level)
0–127 Adjusts the output level of the sound that passes through the vocoder.