Roland JD-XA - 24: Step Flg (Step Flanger); 25: Hexa-Cho (Hexa-Chorus)

34
Eects
24: Step Flg
(Step Flanger)
This is a anger in which the anger pitch changes in steps. The
speed at which the pitch changes can also be specied in terms of a
note-value of a specied tempo.
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Step Flanger
Step Flanger
Parameter Value Explanation
Filter Type OFF, LPF, HPF
Type of lter
OFF: no lter is used
LPF: cuts the frequency range above
the Cuto
HPF: cuts the frequency range
below the Cuto
Cof Freq
(Cuto Freq)
200–8000 Hz
Center frequency when using the
lter to cut a specic frequency
range
Pre Delay 0.0–100.0 ms
Adjusts the delay time from the
direct sound until the anger sound
is heard.
Sync Hz, NOTE
Hz: The Rate value is specied in Hz.
NOTE: The Rate value is specied as
a note value.
Rate #
0.05–10.00 Hz,
note
Rate of modulation
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback # -98–+98%
Adjusts the proportion of the anger
sound that is fed back into the
eect.
Negative (-) values invert the phase.
Step Sync Hz, NOTE
Hz: The Rate value is specied in Hz.
NOTE: The Rate value is specied as
a note value.
StepRate #
0.10–20.00 Hz,
note
Rate (period) of pitch change
Low Gain -15–+15 dB Amount of low-range boost/cut
High Gain -15–+15 dB Amount of high-range boost/cut
Balance #
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the anger sound (W)
Level 0–127 Output volume
25: Hexa-Cho
(Hexa-Chorus)
Uses a six-phase chorus (six layers of chorused sound) to give
richness and spatial spread to the sound.
Balance W
Balance W
L in
R in
L out
R out
Hexa Chorus
Balance D
Balance D
Parameter Value Explanation
Pre Delay 0.0–100.0 ms
Adjusts the delay time from the
direct sound until the chorus sound
is heard.
Sync Hz, NOTE
Hz: The Rate value is specied in Hz.
NOTE: The Rate value is specied as
a note value.
Rate #
0.05–10.00 Hz,
note
Rate of modulation
Depth 0–127 Depth of modulation
Pre Delay Dev
(Pre Delay Deviation)
0–20
Adjusts the dierences in Pre Delay
between each chorus sound.
Depth Dev
(Depth Deviation)
-20–+20
Adjusts the dierence in modulation
depth between each chorus sound.
Pan Dev
(Pan Deviation)
0–20
Adjusts the dierence in stereo
location between each chorus
sound.
0: All chorus sounds will be in the
center.
20: Each chorus sound will be
spaced at 60 degree intervals
relative to the center.
Balance #
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output volume